index

How to Install your DynamicDucts™


Shipping Note: If your DynamicDucts arrived with white tape and a small “stick” attached, simply remove and discard it. This piece is only added to protect the ducts during transit. We’re actively refining our packaging methods as couriers have become increasingly rough with parcels.

Step 1: Locate the 4 Bolts used for Install

Ensure your vehicle is parked on a level surface with the parking brake engaged. If you choose to lift the car (not required), use proper equipment and follow all safety precautions.



Locate the 4 mounting points for the DynamicDucts™

  • Bolt #'s 1 & 2 are located on the Drivers side
  • Bolt #'s 3 & 4 are on the passenger side

    Remove these 4 x TORX Plus EP-14 Bolts using a proper EP-14 socket as seen below. These bolts will be re-used to install your new DynamicDucts™


    • Step 2: Install DynamicDucts™



  • Place the DynamicDuct marked "D" or "Drivers Side"" up into the opening, with the grill guard facing the front of the car. Replace the two Ep-14 TORX Plusbolts removed in step 1. DO NOT overtighten these when replacing them, as you could damage the DynamicDucts. Install them to be "snug", will be just perfect. We recommend 19-20 ft-lbs of torque with a dab of loctite.
  • Repeat the same process on the Passenger Side using the Duct marked with "P" or "Passenger Side" to install the 2nd DynamicDuct,


    Note: As a precaution we recommend you put a dab of LOCTITE threadlocker on each of the bolts when re-installing , to ensure they never come loose.

    • Step 3: DRIVE !!!





    Shop DynamicDucts™